The easiest software to use in this case is Repetier-Server.Īfter that you only need to add your printer to Cura with the network options, setting up the IP manually. Usually, you use it to upload files and send the print command to your printer. To achieve these you must set up a server and install software on it that can manage your printer. It’s a little bit trickier but it’s possible! You can control remotely your printer with Cura if you want. I will be speaking about e -steps in another article. Using this information and simple math formula can resolve lots of problems and issues with your printer like over extrusion / under extrusion. Setting your e-steps needs you to manually input the distance extruded so you can check the difference between the demanded length and the actual length extruder by the printer. Benefits connecting your printer to a computer Setting up your E-steps Testing and calibrating different values. The main benefit of doing so is that you can manually send G codes to your printer, this is fundamental for So perhaps you are asking why should I control my 3d printer from a PC? There are some cases when a damaged cable can lead to a bad connection between the two devices. This is mainly because the printer or the port is used by another program, the correct way of dealing with this is to safely remove the device and reconnect but sometimes doesn’t work that way so restarting your device is strongly advised. Problem connecting to Cura? Port arleady used
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |